|
Anti-Vibration Pads
Zebra Anti-Vibration Pads are made from high quality Rubber
elastomeric materials, specially compounded to resist aging,
compression set, water and oil.
These pads are designed and constructed with alternate rib
height to offer additional vibration isolation under both high
and low weight loads.
Available in an all-rubber pad with cross-ribbed design; also, a
cross-ribbed pad 1/2" cork center for additional sound
isolation. Durometer of all-rubber pad: 60±5 point on "A" scale.
Standard sheet size is 18"x18" the all rubber is 3/8" thick.
Smaller sizes are available in the cork and rubber pad.
Cork and Rubber Pads
Neoprene for resiliency combined with cork for sound isolation.
|
Sizes: |
7/8"x18"x18" |
| 7/8"x6"x6" |
| 7/8"x4"x4" |
| 7/8"x3"x3" |
| 7/8"x2"x2" |
All-Rubber Pads
INSTALLATION DATA
The Zebra Anti-Vibration Pad should be measured and cut so there
is no more than 50 pounds per square inch of machine weight on
it when installed. Since most machinery is designed with
approximately 50 PSI maximum base loading, cutting a pad the
size of each foot on the machine, allowing for 1/2" overlap all
around, will generally insure proper loading.
To dampen vibration, a machine weighing 2400 pounds will require
Zebra Anti-Vibration Pad approximately 6"x8" (2400/50 PSI=48
sq. inches or a 8"x6" pad). A pad 3"x4" under each leg is
required, provided the weight is distributed evenly among the
four legs. Tilt-back presses normally carry more weight on the
rear legs and therefore pad size should be adjusted accordingly.
For impact machines such as punch presses, drop hammers, etc., a
lesser loading capacity is recommended generally 25 PSI. A
double thickness of pad may be used to accomplish proper loading
if desired.
In cases where hold-down bolts are necessary, the bolts should
be isolated from the machine.
RECOMMENDED MAXIMUM LOADING CAPACITY: 50 POUNDS PER SQUARE INCH.
|
|
